Search results

Create the page "In-line heater" on this wiki! See also the search results found.

• Drying wet biodiesel
  ...ay to warm your biodiesel up, possibly by using your biodiesel processor's heater, or by adding a heating element to your washing tank.
  4 KB (731 words) - 18:41, 5 March 2013
• Water washing
  ...pump running. You may well hear the popping as suspended water around the heater turns to steam.
  11 KB (1,836 words) - 18:51, 5 March 2013
• Processor - with methanol condenser (GL design)
  This table tells you about the status of each valve, the heater and pump at various stages of the process. State diagram: Green = valve open, pump running or heater on.
  24 KB (4,148 words) - 21:10, 3 March 2013
• Processor - with pre-heat / drying tank
  This table tells you about the status of each valve, the heater and pumps at various stages of the process. State diagram: Green = valve open, pump running or heater on.
  16 KB (2,677 words) - 23:05, 30 July 2013
• Biodiesel process guide
  # Heat your oil to 55°C and turn off heater (make sure your pump is on and circulating)
  4 KB (711 words) - 08:49, 22 July 2015
• Filter modification for Peugeot and Citroen
  ...Peugeot 205 306 405 406 fuel heater, Citroen fuel heater, Fiat Ducato fuel heater, heated filter, Penny trick, </metadesc>
  3 KB (422 words) - 17:23, 26 January 2014
• Waste oil filtering system
  * Immersion heater element + back nut flange File:Bottom-heater-drum.jpg|Heater element and safe zone/crud layer.
  3 KB (466 words) - 20:46, 29 January 2011
• Heat exchangers and solenoid valves
  ...espectivly.These are readily available from oilbits in sizes to match your heater hoses ID. File:Heat-ring.jpg|Heater ring that fits standard spin on cartridge type filters.
  3 KB (452 words) - 17:35, 26 January 2014
• Processor - basic design
  ...ocked with a [[processor level switch]] or that a non siphoning, [[in-line heater]] is used. This table tells you about the status of each valve, the heater and pump at various stages of the process.
  12 KB (1,976 words) - 20:34, 3 March 2013
• Processor buyers guide
  ...methanol fumes to go near any equipment that may generate heat (immersion heater elements) or sparks (switches or motors) ...Eprocessor.jpg|250px|thumb|right|Result of over heating where an immersion heater is mounted directly in a HDPE processor.]]
  4 KB (618 words) - 21:52, 3 March 2013
• Processor pressure switch
  ...witch, Biodiesel processor heater safety interlock, Inhibiting a Biodiesel heater, Interlocking a Biodiesel processor, Biodiesel processor controls, Processo To reduce the risk it is sensible to fit a deadlock on the heater element to ensure that it cannot be switched on unless the element is compl
  3 KB (448 words) - 23:46, 3 March 2013
• Processor - Appleseed
  ...te with the Appleseed processor is that it is based on a standard US water heater which is a pressurised vessel. The original design concept sealed the proce This table tells you about the status of each valve, the heater and pump at various stages of the process.
  10 KB (1,707 words) - 22:51, 30 July 2013
• Fitting a heater flange
  Soldering a flange ring to a barrel for an immersion heater. When fitting an immersion heater flange to a thin walled tank if sufficient heat is available to overcome th
  2 KB (348 words) - 20:47, 24 June 2012
• Multi-tasking processor
  *18" immersion heater <td align="center" width="41">Heater</td>
  18 KB (2,597 words) - 12:40, 1 March 2013
• Simple fat melting and de-watering tank
  ...nt instructions by Rotary-Motion, for [[Fitting_a_heater_flange|mounting a heater flange]] can be followed here. ==Rolling the heater tube==
  7 KB (1,209 words) - 22:14, 3 March 2013
• Processor / tank float switch
  ...nol is present. To reduce the risk it is sensible to fit a deadlock on the heater element to ensure that it cannot be switched on unless the element is compl
  4 KB (616 words) - 23:42, 3 March 2013
• Thermocouples
  ...sed to trigger an alarm or a high temperature shut down of the processor's heater. Typically they will have positive and negative connections for the thermo ...tank whilst processing, but when distilling you may require to control the heater using a still head thermocouple.
  20 KB (3,039 words) - 00:03, 20 March 2013
• Plumbing fittings
  Fitting a heater flange ring [http://www.biopowered.co.uk/wiki/Fitting_a_heater_flange HowTo File:Heater_flange.jpg |Heater ring (solder on)
  9 KB (1,437 words) - 20:34, 1 March 2013
• Melting stick
  The melting stick is constructed using a 220-240 volt cartridge heater. These are readily available from on-line auction sites and other outlets. # ... 1 off ... cartridge heater 15mm outside diamater, 300W (available in various wattages)
  4 KB (675 words) - 12:27, 1 March 2013
• SSR - solid state relay
  ...nder fault conditions. If there is Mains supply to the SSR, and the load (heater, motor etc) is disconnected or faulty then there will be a Voltage at the O
  5 KB (784 words) - 19:32, 14 July 2013

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)