Author Topic: DIY syphon nozzle (Read 32660 times)

julianf · « **Reply #60 on:** July 30, 2015, 09:19:59 PM »

this one may be better -

http://heating.danfoss.com/PCMPDF/BFP10-11_VDDKQ202.pdf

shows settings for one pipe, or looped opperation.

it may be interesting for you to stick a pressure gauge on it also, but possibly not, if youre never going to be pumping at pressure.

Tony · « **Reply #61 on:** August 06, 2015, 10:38:22 AM »

Next problem.

I have a motor EOGB M02-1-90-13 (brand new one, for cheap!) and aforementioned Danfoss BFP 11L3 pump (I understand L means left hand, rotates anti-clockwise), the two fit together but need some form of coupling to join them.

Is this the right coupling? Are Riello and Danfoss pumps interchangable?

http://www.ebay.co.uk/itm/RIELLO-OIL-PUMP-DRIVE-COUPLING-RDB-AND-MECTRON-3000443-/191624698084

Or something like this?

http://www.ebay.co.uk/itm/BENTONE-SINGLE-STEP-DRIVE-COUPLING-C01-00-117-56802-SIMEL-AEG-B9-Pump-dog-/141607047964

(nearly a fiver for a bit of plastic ain't happening, I'd rather print one)

therecklessengineer · « **Reply #62 on:** August 06, 2015, 01:19:51 PM »

A bit of hose and two jubilee clips works quite nicely if you're not too bothered about a 'proper' engineering solution.

Tony · « **Reply #63 on:** August 06, 2015, 01:30:04 PM »

Hehe I like your thinking!

Sadly this is not a shaft to shaft coupling, the pump has a shaft with a flat and the motor has a recessed pocket in the back that takes some keyed coupler.

Chug · « **Reply #64 on:** August 07, 2015, 12:44:46 AM »

mine are in parts like this,
http://www.uk-plumbing.com/eogb-drive-coupling-inter-11-10-12-109-99-p-55576.html

Biopowered - vegetable oil and biodiesel forum

General

Alternative heat and power

DIY syphon nozzle