Cone bottoms for tanks
 This page is Work In Progress and therefore may not be complete.
|
Forget the hole in the top for the time being so, to find length of sloping side ‘L’
Base dia ‘D’ = 570mm (typical for a 205 litre steel drum, but check before proceeding) hence base radius ‘R’ is half this = 285 Desired angle ‘a’, say = 45°
For any size cone where angla a is 45° L = Square root of 2 (1.414) x R
To address the hole in the top, use the same formula but substitute the diameter of the fitting you want to use for the base diameter, say 30mm
Hence if D = 30, R will = 15
l = Square root 2 (1.414) x 15 = 21.21
We are aiming for this shape to roll into the cone,
so we need to know the angle between the two edges (b°).
We’ve already calculated L, 403mm.
The Included angle is simple to work out it's 180 x D / L
Giving us 180 x 570 / 403 = 254.59°
To fabricate a 60° cone draw a semi-circle with a radius equal to the finish diameter, for a steel drum that's 570mm. The hole at the apex is the same, use a radius the same as the finished diameter.
- Steps in producing a cone bottom
Blank for cone. Source: Rob-b
Arc for cone cut from blank. Source: Rob-b
Arc formed to cone and tack welded Source: Rob-b
Finished cone with fitting welded to tank. Source: Rob-b
