Cone bottoms for tanks

This page is Work In Progress and therefore may not be complete.

This is currently a draft page for JamesRL's scrutiny.

Forget the hole in the top for the time being so, to find length of sloping side ‘L’

Base dia ‘D’ = 570mm (typical for a 205 litre steel drum, but check before proceeding) hence base radius ‘R’ is half this = 285 Desired angle ‘a’, say = 45°

For any size cone where angla A is 45° L = Square root of 2 (1.414) x R

To address the hole in the top, use the same formula but substitute the diameter of the fitting you want to use for the base diameter, say 30mm Hence if D = 30, R will = 15

l = Square root 2 (1.414) x 15 = 21.21

We are aiming for this shape to roll into the cone,

so we need to know the angle between the two edges (b°). We’ve already calculated L, 403mm.

The Included angle is simple to work out it's 180 x D / L

Giving us 180 x 570 / 403 = 254.59°

To fabricate a 60° cone draw a semi-circle with a radius equal to the finish diameter, for a steel drum that's 570mm. The hole at the apex is the same, use a radius the same as the finished diameter.

• Steps in producing a cone bottom
• 

  Blank for cone. Source: Rob-b

• 

  Arc for cone cut from blank. Source: Rob-b

• 

  Arc formed to cone and tack welded Source: Rob-b

• 

  Finished cone with fitting welded to tank. Source: Rob-b