Vegetable oil as fuel

This page is Work In Progress and therefore may not be complete.

Introduction to Vegetable Oil as Fuel

It is possible for any diesel engine to run with vegetable oil as a replacement to diesel fuel but the ancillary fuel system components and the design of the engine itself may make long term use of vegetable oil as a fuel impractical or impossible.

Before you embark on using vegetable oil as a fuel there are many factors to be considered and they fall loosely into three categories, the suitability of the vegetable oil, the suitability of the engine and the suitability of the fuel system.

The Suitability of the Engine

In order to discover whether it is possible to use vegetable oil as fuel in your engine, your first step will be to establish exactly which engine and injection system you have. Armed with this information and some basic rules you can then move on to cross check against the rules and possibly even with some databases of users who have successfully (and sometimes unsuccessfully) run their engines on vegetable oil.

Indirect Injection Engines

Indirect injection engines (those with glow plugs and pre-swirl chambers) are the most suitable engines for running vegetable oil as fuel. Due to their design, there is more chance of complete combustion due to better mixing with air, higher temperatures in the swirl chamber, and unlike direct injection engines,the fuel is not sprayed directly into the cylinder.

Direct Injection Engines

The primary problem with direct injection engines when using vegetable oil as fuel is that until the engine has reached operating temperature, the more viscous and therefor poorly atomised fuel is injected into a cold cylinder resulting in the possibility of unburnt fuel hitting the cylinder walls and being swept up by the piston rings. Eventually this unburnt fuel forms a hard rubbery mass (similar to what can be found on the bottom of a well used frying pan) which gums the piston rings into their grooves and prevents them following the contours of the cylinder, resulting in loss of compression.

If vegetable oil is to be used in a direct injection engine, some means of lowering its viscosity to aid atomisation and encourage a complete burn must be used. Typically this could be blending with a thinning agent or heating the vegetable oil prior to it's injection into the cylinder.

The Suitability of the Fuel System

CAUTION – Incorrect choices here could result in major fuel system damage.

There are several systems of injecting the fuel into a diesel engine. The most common injection systems are inline pump, rotary pump, unit injectors and common rail. Some of these systems are more suited to vegetable oil than others and some are so sensitive and expensive to repair that the risks involved are generally prohibitive.

Inline pump

Older diesel engines are often fitted with inline injection pumps. They are still a popular choice for many modern lorries, construction plant, static engines and agricultural vehicles. Their robustness and simplicity often makes them very tolerant of pumping vegetable oil.

Rotary Injection Pumps

Most rotary injection pumps use the fuel that they are pumping to also lubricate the moving parts within the pump. It has been discovered that due to the design and finer tolerances within Lucas/CAV injection pumps, at lower operating temperatures they are unable to feed the more viscous vegetable oil to the areas that need lubrication and as a result there have been many recorded cases of the rotor seizing within the pump body causing failure of the shaft. This problem has been successfully overcome in many cases using a twin tank system where the engine is brought up to operating temperature using diesel from one fuel tank and then once up to operating temperature, a switching system is used to change to a separate fuel tank containing vegetable oil. It is important to switch back to diesel towards the end of each journey in order to purge the fuel system of vegetable oil thus enabling the next start up to be on diesel.

Most Bosch rotary pumps and the 'made under license' Japanese versions are far more tolerant to viscous vegetable oil and there are many reports of engines equiped with these pumps having successfully covered tens of thousands of problem free miles.

Unit injectors

THIS PARAGRAPH IS STILL BEING WRITTEN

Common Rail

THIS PARAGRAPH IS STILL BEING WRITTEN

The Suitability of Vegetable Oil

Vegetable oil is not biodiesel. Biodiesel is vegetable oil that has been chemically altered using a reaction called transesterification.

Vegetable oil to be used as fuel can be either new and bought from the cash and carry or supermarket (this is commonly called Straight Vegetable Oil and is abbreviated to SVO) or oil that has been previously used for cooking (this is commonly called Waste Vegetable Oil and is abbreviated to WVO or Used Cooking Oil which is abbreviated to UCO)

SVO is probably the easiest biofuel to use in a suitable diesel engine but is also the most expensive. WVO is a much cheaper and more environmentally friendly alternative as once it has been used for cooking, it becomes a waste product. The downside to this is that it requires processing before use as a fuel.

There are a number of problems associated with using vegetable oil as a fuel in a suitable engine but most of these issues can generally be overcome to an acceptable degree by exercising care when processing your fuel. The main issues with using vegetable oil as fuel are:

Viscosity

Vegetable oil is much more viscous that diesel and will put a greater strain on the fuel system components. It is also harder to obtain a complete burn, especially in a cold engine. You can lower the viscosity of your oil by either heating it before it enters the main fuel system components or by blending it with a thinning agent such as petrol before you put it in your fuel tank.

Contaminates

Used oil will contain food particles and fats which can block the various filters in your fuel system. Filtering liquid, well settled oil to a level below that of your main fuel filter (generally 10 micron) should be done at a similar ambient temperature to when you are intending to use your fuel and should remove food particles and fats.

Water

Used oil may contain suspended water which will cause long term damage to the fuel system and enable the free fatty acids within the oil to become corrosive. Dewatering can be achieved using either the heat and settle method or by boiling the water off.

Energy

Vegetable oils typically contain less energy than diesel so a slight reduction in power and/or fuel economy is common. If this proves to be a problem, some people have had success using products designed to boost the cetane value of your fuel.