Biopowered - vegetable oil and biodiesel forum

General => Chatter => Topic started by: Head Womble on December 26, 2012, 02:49:51 PM

Title: Code reader needed
Post by: Head Womble on December 26, 2012, 02:49:51 PM

Anyone close (ish) to heathrow got a code reader that will work on a 2001 pug 306 HDI,
I need to get my daughters plugged in as it's gone into limp home mode, changed the fuel filter and it's still the same,

Ps. £12.69 for a fuel filter from Halfords as it's the only place open today  >:(

Title: Re: Code reader needed
Post by: Julian on December 26, 2012, 03:01:04 PM

Ha, ha, snap!  Golf went into limp mode on Christmas eve ... haven't looked at it yet.

Title: Re: Code reader needed
Post by: Julian on December 26, 2012, 03:31:04 PM

Looked at it now ... it was the ESP light on permanently and presumably the ESP functioning permanently.  After a little rest on Christmas day, all seems normal just ticking over on the drive today, ... phew!   Will take it out for a run later when it's not blocked in.

Sorry that doesn't help you , Mark!

Title: Re: Code reader needed
Post by: Head Womble on December 26, 2012, 04:43:28 PM

Panic over, my daughters mate is going to read the fault codes for me tomorrow.

Here's hoping it's an easy/cheap fix.

Title: Re: Code reader needed
Post by: Head Womble on December 26, 2012, 09:25:25 PM

Well the guy has just been round and reset the fault,
it was diesel pump low inlet pressure, so it was the filter in the end.