Biopowered - vegetable oil and biodiesel forum
Biodiesel => Biodiesel equipment => Topic started by: willbuild on December 10, 2013, 07:36:28 PM
-
I have acquired a 110 ltr indirect cylinder which i plan to use to start a to build my second gl. my question is should i remove the in direct coil or can i leave it inside?
-
It would be near impossible to remove, so that about settles it.
That aside, it will not matter anyhow.
-
saw a clip somewhere where they were removing it through the element hole. did think at the time hard work for very little gain, but thought that maybe i was missing something
-
on my first gl i made my own venturi using the graham method of beating a copper pipe. 8mm throat, pump 40lts per min. it sucks 1 lt per min of water or metoxide from the same level as the base of prossesor (1mt).
Is this good, ok or poor?